Rollover Protection System (Rops) Kit; Install The Rops (International Machines Using Gasoline Only); Roll Bar, Right Section; Roll Bar, Left Section - Toro Z Master Professional 5000 Series Setup Instructions

15
Installing the ROPS
International Machines Using
Gasoline Only
Parts needed for this procedure:
1

Rollover Protection System (ROPS) Kit

Procedure
Install the Rollover Protection System (ROPS) Kit.
Follow the Installation Instructions.
16
Installing the ROPS
Diesel Machines Only
Parts needed for this procedure:
1

Roll bar, right section

1

Roll bar, left section

1

Roll bar, center section

8

Bolt (3/8 x 1 inch)

8

Curved washer

8

Flange nut (3/8 inch)

2

Bolt (1/2 x 3-1/4 inches)

2

Flange nut (1/2 inch)

Procedure
1. Loosely install the right and left roll bar section
to the frame using the 8 bolts (3/8 x 1 inch), 8
curved washers, and 8 flange nuts (3/8 inch).
Note:
Install the curved washer cone toward
the bolt head.
2. Install the lanyard clips onto the long bolts (1/2 x
3-1/4 inches).
Note:
Ensure that the bent tab points toward
the head of the bolt.
3. Lightly oil the ends of the center roll bar section.
4. Loosely install the center roll bar section using
2 bolts (1/2 x 3-1/4 inches) and 2 flange nuts
(1/2 inch).
Note:
Install the bolts from the outside of the
roll bar.
Note:
Install the lanyard tab oriented as shown
in Figure 25 and pointing forward.
11
Figure 23
Figure 24
g001077
g001072