Configuration Using Bar Codes; Configuration Parameters - Wasp WWS650 Product Reference Manual

This and following sections provide programming bar codes to configure your reader by chang-
ing the default settings. For details about additional methods of programming, see
tion Methods" on page
You must first enable your reader to read bar codes in order to use this section. If you
have not done this, go to
procedure.
NOTE

Configuration Parameters

Once the reader is set up, you can change the default parameters to meet your application
needs. Refer to "Standard Defaults"
the default values and select the interface for your application.
The following configuration parameters are divided into logical groups, making it easy to find
the desired function based on its reference group.
Interface Configuration:
• "RS-232/USB-Com Interfaces" on page 30
• "Keyboard Settings" on page 37
Parameters common to all interface applications:
• "Data Format"
• "Reading Parameters"
functioning.
Symbology-specific parameters:
• "1D Symbologies"
code families and their options.
• "2D Symbologies"
code families and their options.
You must first enable your reader to read bar codes in order to use this section. If you
have not done this, go to
procedure.
NOTE
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each programming
page, when applicable.
2. Scan the bar code to set the desired programming feature. You may need to cover unused
bar codes on the page, and possibly the facing page, to ensure that the reader reads only
the bar code you intend to scan.
Product Reference Guide

Configuration Using Bar Codes

4.
Setup, starting on page 9
starting on page 277 for initial configuration in order to set
on page 51 gives options to control the messages sent to the Host system.
on page 65 control various operating modes and indicators status
on page 85 provides configuration of a personalized mix of 1D codes,
on page 177 provides configuration of a personalized mix of 2D codes,
Setup, starting on page 9
Chapter 3
and complete the appropriate
and complete the appropriate
"Configura-
21