Lcd Messages - Canon LASER CLASS 730i User Manual

LCD messages

Message (Error code)
Fax Model AUTO REDIAL
Bk INK EMPTY
Fax Model BUSY/NO
SIGNAL (#018)
C INK EMPTY
CANNOT USE THIS CARD
TURN OFF AND ON
CARD READER BUSY
CARTRIDGE JAMMED
Fax Model CHANGE
PAPERSIZE:FAX
Chapter 12
Cause
The machine is waiting to redial
the other party's number
because the line was busy or the
recipient did not answer when
you tried to send a document.
The black ink tank in the
printhead is empty.
The telephone number you
dialed is busy.
The fax number dialed was
incorrect.
The other party's fax machine is
not working.
The other party is not using a G3
machine.
The touch tone/rotary pulse
setting on your machine is
incorrect.
The receiving fax machine did
not answer within 55 seconds
(after all automatic redialing
attempts).
The cyan ink tank in the
printhead is empty.
You have inserted a Microdrive
memory card or a damaged card
into the card slot.
You tried to start photo printing
when the memory card slot was
in use by the computer.
The printhead holder cannot
move. This is normally due to a
paper jam.
The print media size setting is set
to a size other than <LTR>,
<LGL>, or <A4>.
Action
Wait for the machine to automatically
redial the number. If you want to
cancel automatic redialing, wait until
the machine starts dialing the
number, press [Stop/Reset], then
follow the instructions in the LCD.
Replace the ink tank.
Try sending the document at a later
time.
Check the fax number and dial again.
Contact the other party and have
them check their fax machine.
Contact the other party and ask them
to send or receive the document
using a G3 machine.
Set your machine to the setting that
matches your telephone line.
Contact the other party and have
them check their fax machine. You
can try to send the document using
manual sending. For an overseas call,
add pauses to the registered number.
Replace the ink tank.
Remove the memory card from the
slot, then turn the power off and on
again.
You cannot use Microdrive memory
cards with this machine.
Wait until the memory card slot is no
longer being used by the computer.
Clear the paper jam or whatever is
obstructing the printhead holder and
then press [Resume]. Do not attempt
to move the printhead holder
manually.
Set the print media size setting to
<LTR>, <LGL>, or <A4> and load
paper of the same size. The received
fax will then be printed automatically.
Troubleshooting
Details
p. 8-5
p. 11-2
p. 6-4
p. 8-2
p. 11-2
12
p. 4-1
p. 12-15
p. 3-6
12-19