Mitsubishi Electric FR-F 700 EC Instruction Manual page 76

Operation Panel
Indication
Name Input phase failure
This alarm is output when function valid setting (=1) is set in Pr. 872 Input phase failure protection selection and
Description
one phase of the three phase power input opens. (Refer to
Check point Check for a break in the cable for the three-phase power supply input.
· Wire the cables properly.
Corrective action
· Repair a brake portion in the cable.
· Check the Pr. 872 Input phase failure protection selection setting.
Operation Panel
Indication
Name
Stall prevention
If the frequency has fallen to 0.5Hz by stall prevention operation and remains for 3s, an alarm (E.OLT)
Description
appears to shutoff the inverter output. OL appears while stall prevention is being activated.
Check point
· Check the motor for use under overload. (Refer to
Corrective action · Reduce the load weight.
Operation Panel
Indication
Name
Output side earth fault overcurrent
This function stops the inverter output if an earth fault overcurrent flows due to an earth fault that
Description
occurred on the inverter's output (load) side.
Check point
Check for an earth fault in the motor and connection cable.
Corrective action
Remedy the earth fault portion.
Operation Panel
Indication
Name
Output phase failure
This function stops the inverter output if one of the three phases (U, V, W) on the inverter's output side
Description
(load side) opens.
· Check the wiring (Check that the motor is normal.)
Check point
· Check that the capacity of the motor used is not smaller than that of the inverter.
· Wire the cables properly.
Corrective action
· Check the Pr. 251 Output phase failure protection selection setting.
Operation Panel
Indication
Name External thermal relay operation
If the external thermal relay provided for motor overheat protection, or the internally mounted
Description
temperature relay in the motor, etc. switches on (contacts open), the inverter output is stopped.
· Check for motor overheating.
Check point
· Check that the value of 7 (OH signal) is set correctly in any of Pr. 178 to Pr. 189 (input terminal function
· Reduce the load and operating duty.
Corrective action
· Even if the relay contacts are reset automatically, the inverter will not restart unless it is reset.
*4 Functions only when any of Pr. 178 to Pr. 189 (input terminal function selection) is set to OH.
Operation Panel
Indication
Name
PTC thermistor operation
Appears when the motor overheat status is detected for 10s or more by the external PTC thermistor
Description
input connected to the terminal AU.
· Check the connection between the PTC thermistor switch and thermal protector.
· Check the motor for operation under overload.
Check point
· Is valid setting ( = 63) selected in Pr. 184 AU terminal function selection ? (Refer to
Corrective action Reduce the load weight.
E.ILF
E.OLT
E.GF
E.LF
E.OHT
selection).
E.PTC
Manual (applied).)
Causes and corrective actions
FR-PU04 Fault 14
Instruction Manual (applied).)
Still Prev STP ( OL shown during stall
FR-PU04
prevention operation)
Instruction Manual (applied).)
FR-PU04 Ground Fault

FR-PU04
FR-PU04 OH Fault
*4
FR-PU04 Fault 14
5
Instruction
69