Table of Contents
Advertisement
Make a start and stop with terminals
(external operation)
9.
While the value is flickering,
press
to set the frequency.
If you do not press
for about 5s and the display then returns
to 0.00 (display) Hz. At this time, return to
"Step 3" and set the frequency again.
10.
Turn the start switch (STF or STR) off.
The motor decelerates according to
Pr. 8 Deceleration time to stop.
REMARKS
· Pr. 178 STF terminal function selection must be set to "60" (or Pr. 179 STR terminal function selection must be set to "61").
(all are initial values)
· When Pr. 79 Operation mode selection is set to "3", multi-speed operation (refer to page 43) is also made valid.
When the inverter is stopped by
displayed alternately.
1. Turn the start switch (STF or STR) off.
2. The display can be reset by
42
Operation
,the value flickers
of the operation panel (FR-DU07),
Display
Flicker ··· Frequency setting complete!!
Forward
rotation Reverse
rotation
OFF
.
Stop
and
are
Flickering
Advertisement
Table of Contents
