Table of Contents
Advertisement
Understanding the printer menus
Network Card menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > Network Card
•
Network/Ports > Network [x] > Network [x] Setup > Network Card
Use
View Card Status
Connected
Disconnected
View Card Speed
Energy Efficient Ethernet
Enable
Disable
Network Address
UAA
LAA
Job Timeout
0, 10–225 seconds
Banner Page
Off
On
TCP/IP menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > TCP/IP
•
Network/Ports > Network [x] > Network [x] Setup > TCP/IP
Note: This menu is available only in network printers or printers that are attached to print servers.
Use
Set Hostname
IP Address
Netmask
Gateway
To
View the connection status of the wireless network adapter.
View the speed of an active wireless network adapter.
Reduce power consumption when the printer receives no data from the
Ethernet network.
Note: Enable is the factory default setting.
View the network addresses.
Set the amount of time it takes for a network print job to be canceled.
Notes:
•
90 seconds is the factory default setting.
•
A setting value of 0 disables the timeout.
•
A value between 1 and 9 is invalid.
Allow the printer to print a banner page.
Note: Off is the factory default setting.
To
Set the current TCP/IP hostname.
View or change the current TCP/IP address.
Note: Manually setting the IP address sets the Enable DHCP and Enable Auto
IP settings to Off. It also sets Enable BOOTP and Enable RARP to Off on
systems that support BOOTP and RARP.
View or change the current TCP/IP netmask.
View or change the current TCP/IP gateway.
73
Advertisement
Table of Contents
