Table of Contents
Advertisement
Understanding the printer menus
Use
Network Buffer
Auto
3KB to [maximum size allowed]
Job Buffering
Off
On
Auto
Mac Binary PS
On
Off
Auto
Standard Network Setup OR
Network [x] Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
Reports menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > Reports
•
Network/Ports > Network [x] > Network [x] Setup > Reports
Use
To
Print Setup Page Print a report containing information about the network printer settings, such as the TCP/IP
address.
To
Set the size of the network input buffer.
Notes:
•
Auto is the factory default setting.
•
The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buffers, and whether Resource Save is
set to On or Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
The printer automatically restarts when the setting is changed from the
control panel.
Temporarily store print jobs in the printer hard disk before printing. This menu
only appears when a formatted disk is installed.
Notes:
•
Off is the factory default setting.
•
The printer automatically restarts when the setting is changed from the
control panel. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Note: Auto is the factory default setting.
Show and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a
wireless network.
72
Advertisement
Table of Contents
