Step 5 Checking Operations With The Diagnosis Program; What Is The Diagnosis Program; Check Method - Contec DA16-16L User Manual

2. Setup
Step 5 Checking Operations with the Diagnosis
Program
Use the diagnosis program to check that the board and driver software work normally, thereby you can
confirm that they have been set up correctly.

What is the Diagnosis Program?

The diagnosis program diagnoses the states of the board and driver software.
It can also be used as a simple checker when an external device is actually connected.
Using the "Diagnosis Report" feature reports the driver settings, the presence or absence of the board,
I/O status, and interrupt status.

Check Method

To check the analog output data, connect to an external signal source.
The figure below shows an example of checking by connecting to an external signal.
The analog output example illustrated below is an example of using analog output channel 0
on the DA16-16(LPCI)L or DA16-8(LPCI)L.
Connection diagram
< Analog Output >
Interface connector
CH0
(CN1)25pin
e.g.Tester
Analog Ground
(CN1)24pin
Figure 2.4. Connection diagram
21
DA16-16(LPCI)L, DA16-8(LPCI)L