2. Setup
Step 2 Setting the Hardware
This section describes how to set this product and plug it on your PC.
This product has some switches and jumper to be preset.
Check the on-board switches and jumpers before plugging this product into an expansion slot.
This product can be set up even with the factory defaults untouched. You can change board settings
later.
Replacing the Bracket
This product is shipped with a Low Profile size bracket mounted. To plug this product into a standard
size slot, replace the bracket with the bundled standard size bracket. The replacing method is as
follows :
Standard size bracket
- Remove the screws and replace it
with the Standard size bracket.
Low Profile size bracket
Screws
Use a standard screwdriver to attach and detach the screws.
Figure 2.1. Replacing the Bracket
14
DA16-16(LPCI)L, DA16-8(LPCI)L