Cleaning The Doors - Cannon C60DP Use And Installation Instructions

CLEANING THE DOORS

Take particular care not to damage the inner surface of the door inner glass that
is coated with a heat reflective layer. Do not use scouring pads, or abrasive
powder, which will scratch the glass.
Ensure that the glass panel is not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool soap pad. For slight soiling
the inner glass panel may be cleaned, while still warm, without removing it from the
door. After cleaning, rinse and dry with a soft cloth.
SIDE OPENING DOOR
Cleaning the door glass is the same as the drop down door, except take care to
support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and remove the extrusion end caps (This should be done by
hand but if it proves too difficult, simply lift the inner glass to ease the end caps out
of position).
Note: If you need to use a tool - be careful not to damage the extrusion or end
cap.
2.
3. The inside of the outer door glass can now be cleaned while still fitted to the cooker.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots, so that the printing is readable from the
face nearest the oven in the closed position and the widest black band is towards
the bottom of the door. The inner door glass has a special reflective coating on one
side, in order to minimise surface temperatures and energy consumption during
use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it will go and replace the end caps.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
30
CARE AND CLEANING
Carefully slide the inner glass towards you and withdraw it
from its locating slots.
Ensure that the door is not allowed to slam shut, due to the
reduction in door weight.
Clean the glass as described above.