Linking Method For F-4G System - FUTABA T10PX Short Manual

Linking Method For F-4G System

(Display when power switch turned on)
When the power switch is turned on, the currently selected model number is displayed. Check if this num-
ber is the model number you want to set-up. To change the model number, use the Model Select function.
Receiver system check
The model number is displayed.
Before setting up each function of the
transmitter, check and set the follow-
ing items.
RF Output & Rx Type Check
Check if the receiver system is set to the type of receiver used.
*When the "PWR" side power switch is set to ON and radio waves are output normally, "F-4G", "T-FHSS SR", "T-
FHSS", "Mini-Z"or "S-FHSS" is displayed. If not displayed, there is probably an abnormality or trouble so contact
a Futaba Service Center. When a screen is displayed at the "DSP" side, "Display" is displayed.
*Since the R404SBS(E) receiver supplied with the T10PX set uses the F-4G system, T10PX receiver setup must be
set to F-4G.
Receiver system Change & How To Link
First set up the receiver. Setting changes are immediately reflected. Next, the transmitter and receiver are
linked and the receiver memorizes the transmitter ID number so that signals from other transmitters will
not be received. In addition, with the Telemetry system, the transmitter simultaneously memorizes the
receiver ID numbers so that data from other receivers will not be received.
The method of setting up the receiver system and the method of linking the transmitter and receiver are
described.
1
Set the transmitter "PWR" side power switch to ON. From the Home screen, press the
HOME button or tapped [Menu] on the touch panel. Next, select [Receiver] at the Link-
age menu and access the setup screen shown below by tapping the screen.
HOME
Preparations
Turn on the transmitter power.
Menu
34
Voltage check
The telemetry ON/OFF and com-
munication status checked.
(HOME screen)
Linkage menu Receiver