Table of Contents
Advertisement
●EXT battery terminal
The voltage can be displayed at the transmitter by branch connecting the drive battery, etc. installed in
the fuselage with the CA-RVIN-700 cable sold separately.
●Battery fail safe function
CONTENTS AND TECHNICAL SPECIFICATIONS
Your 10J includes the following components:
• T10J transmitter for airplanes or helicopters
• R3008SB Receiver
• Switch harness
• Neck strap
*The set contents depend on the type of set.
Transmitter T10J
(2-stick, 10-channel, T-FHSS Air-2.4G system)
Transmitting frequency: 2.4GHz band
System: T-FHSS Air, S-FHSS, switchable
Power supply: 6.0V Dry battery
Receiver R3008SB
(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS system)
Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)
Size: 0.98 x 1.86 x 0.56 in. (24.9 x 47.3 x 14.3 mm)
Weight: 0.36 oz. (10.1g)
Battery F/S Voltage: It sets up with a transmitter
(*1) When using ESC's make sure that the regulated output capacity meets your usage application.
SYSTEM COMPATIBILITY
The 10J is a 2.4GHz T-FHSS Air system . The transmitter can also be switched to S-FHSS . (However, the telemetry
system cannot be used with S-FHSS.) The usable receivers are shown below.
Communications System
T-FHSS Air
（Default）
S-FHSS
（Change is possible）
NOTE：
*The Futaba T-FHSS Air system cannot be used with Futaba S-FHSS/FASST/FASSTest systems. Use
it with a T-FHSS Air system transmitter and receiver. The T10J is a T-FHSS Air system , but can also
be used with an S-FHSS receiver by switching to S-FHSS . However, in this case the telemetry system
cannot be used.
*The T-FHSS Air system and T-FHSS surface system are different. The T10J cannot be used with the
R304SB, R304SB-E or T-FHSS surface system receivers.
(Specifications and ratings are subject to change without notice.)
Usable Receivers
R3008SB
*R304SB, R304SB-E, T-FHSS surface system
receivers do not operate.
R2008SB
R2006GS
R2106GF
13
Advertisement
Table of Contents
