New Holland 200 Series Service Manual page 18

Tier 4b (final) skid steer loader tier 4b (final) compact track loader
Hide thumbs Also See for 200 Series:
Table of Contents

Advertisement

3. Install the retaining nuts. Torque the nuts to 170 N·m
(125 lb ft).
Unlock and lower the loader arm for machine operation
WARNING
Crushing hazard!
ported during support strut removal.
Do not enter or exit the operator's compart-
ment with an unsupported loader arm. Two
persons are required during storage. One per-
son should remove and store the support strut
while the operator remains in the operator's
compartment.
Failure to comply could result in death or se-
rious injury.
NOTE: An instructional decal on the inside of the right-
hand loader arm, just above the support strut is also avail-
able. Understand the loader arm unlock procedure before
continuing.
Placing the support strut in the storage position requires
a second person. The operator must remain in the seat
during this procedure.
1. Sit in the operator's seat, fasten the seat belt, and start
the engine.
2. Press the operate button to enable the hydraulics.
3. Raise the loader arm until the support strut (B) is not
resting on the end of the cylinder barrel (C).
4. Instruct the second person to remove the support strut
pin (A) and place the support strut in the stowed po-
sition and reinstall the support strut pin (A). When the
second person has cleared the area, the operator may
now lower the loader arm.
5. Commence work operations or park the machine and
stop the engine.
Loader arms are unsup-
INTRODUCTION
W0077B
48068128 29/01/2018
11
9
931001633
10
RAIL14SSL0418AA
11
93106854A
12
93106848A

Advertisement

Table of Contents
loading

This manual is also suitable for:

L221L228C227C232C237

Table of Contents