Introduction; About This Guide; About The Dtp2 211 Transmitter And Receiver - Extron electronics DTP2 T/R 211 User Manual

Introduction

•
•
•
•

About this Guide

This guide describes the Extron DTP2 211 long distance High Definition Multimedia Interface
(HDMI) Twisted Pair Extenders, which consists of a transmitter and receiver:
•
•
This guide describes how to install, operate, and configure the transmitter and receiver.
About the DTP2 211 Transmitter and Receiver
The Extron DTP2 211 transmitter and receiver pair (see
the usable distance of HDMI digital video with resolutions up to 4K @ 60 Hz (4:4:4), analog
audio, remote power, and bidirectional RS‑232 and infrared (IR) control signals over one
Extron XTP DTP 24 shielded twisted pair (STP) cable (recommended), or Category CAT 6a,
or CAT 7 STP, or unshielded twisted pair (UTP) cable up to 330 feet (100 meters).
The DTP2 211 devices extend the digital signal to Legacy DTP inputs 330 feet
(100 meters) with a maximum resolution of up to 4K @ 30 Hz, 4:4:4, supporting data rates
up to 10.2 Gbps.
The DTP2 211 devices extend the digital signal to DTP2 inputs 330 feet (100 meters)
with a maximum resolution of up to 4K @ 60 Hz, 4:4:4, supporting data rates up to
18 Gbps.
Both units are HDMI (2.0b and 1.4) and HDCP (2.3 and 1.x) compliant. HDCP, EDID, and
CEC transmission is negotiated from source to sink.
•
•
The DTP2 211 transmitter and receiver are housed in 1 inch tall, quarter rack width,
6 inches deep metal enclosures. They can be set on a tabletop, mounted in a rack, or under
or through furniture. The receiver can also be mounted on a projector bracket.
About this Guide
About the DTP2 211 Transmitter and Receiver
Application Diagram
Features
DTP2 T 211 — 330 feet (100 meters) transmitter
DTP2 R 211 — 330 feet (100 meters) receiver
DTP2 transmitters feature configurable analog audio embedding that can be configured
via Simple Instructions Set (SIS) commands.
DTP2 receivers feature configurable digital audio de‑embedding, which can be selected
using the audio toggle switch on the rear panel.
figure 1 on page 2) extends
DTP2 T/R 211 • Introduction 1