Table of Contents
Advertisement
Installation and Operation
This section describes the installation and the operation of the DTP2 211 transmitter and
receiver, including:
•
•
•
Installation Overview
To install and set up the DTP2 211 transmitter and receiver:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Installation Overview
Connections
Operations
Turn off all equipment and disconnect it from the power source.
Mount the transmitter and receiver (optional) on a rack shelf or furniture (see
Mounting the Transmitter or Receiver
Connect an HDMI input source to the DTP2 T 211 input (see figure 2,
page 6).
Connect an HDMI output device to the DTP2 R 211 HDMI output (see figure 3,
page 8).
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
port to reduce stress on the HDMI connectors and prevent signal loss due to
loose cable connections (see
Connect the transmitter DTP2 Out RJ-45 port (see
DTP2 In RJ‑45 port (see figure 3,
Connect an unbalanced stereo audio source to the 3.5 mm mini stereo input on
the DTP2 T 211 (see figure 2,
Connect a balanced or unbalanced stereo or mono audio device to the
DTP2 R 211 via the Audio captive screw output (see figure 3,
Set the Audio configuration toggle switch (see figure 3,
to the UP position to de‑embed digital audio from the HDMI signal and output it to the
captive screw output for analog audio output. Set the Audio configuration toggle
switch to the DOWN position for the analog input from the TRS audio port on the Tx unit
to be transported simultaneously with the digital embedded HDMI audio and output on
the captive screw output (see figure 3,
Connect a serial RS-232 signal, a modulated IR signal, or both into this 3.5 mm,
5‑pole captive screw Over DTP port for bidirectional RS‑232 and IR communication
(see figure 2,
on the transmitter and figure 3,
E
Connect control devices. Connect your computer to the front panel Configuration
port (see figure 9,
on page 15 on the transmitter and receiver) to configure and
B
control the transmitter and receiver via SIS commands.
Power on the output display.
on page 30).
Securing the HDMI Connector
figure 2,
) using a Twisted Pair Cable.
C
) for an analog audio input.
B
).
F
on the receiver).
B
DTP2 T/R 211 • Installation and Operation
on
C
D
on page 10).
) to the receiver
D
).
F
) on the DTP2 R 211
E
5
Advertisement
Table of Contents
