Mercedes-Benz CLA Owner's Manual page 505

502 Wheels and tyres
vertically under the jacking point of the
vehicle.
* NOTE Vehicle damage from the jack
If you do not position the jack correctly at
the appropriate jack support point of the
vehicle, the jack could tip over with the vehi‐
cle raised.
The jack is designed exclusively for
#
jacking up the vehicle at the jack sup‐
port points.
Take the ratchet out of the tyre-change tool
#
kit and place it on the hexagon nut of the
jack so that the letters "AUF" are visible.
Position jack 2 at jack support point 1.
#
Turn ratchet 3 clockwise until jack
#
completely on jack support point
base of the jack lies evenly on the ground.
Turn ratchet 3 until the tyre is raised a max‐
#
imum of 3 cm from the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements:
The vehicle is raised (
R
Mercedes-AMG vehicles: observe the notes in
the Supplement. Otherwise, you may fail to rec‐
ognise dangers.
When changing a wheel, avoid applying any force
to the brake discs, since this could impair the
level of comfort when braking.
* NOTE Damage to threading from dirt on
wheel bolts
Do not place wheel bolts in sand or on
#
a dirty surface.
Unscrew the uppermost wheel bolt com‐
#
2 sits
pletely.
1 and the
Unscrew the remaining wheel bolts fully.
#
Remove the wheel.
#
Fit the new wheel (
#
page 502).
/
page 500).
/
page 503).
/