12 SERVICE WORK ON THE CHASSIS
12.6
58
H03680-10
Installing the fork legs
S04824-13
H03680-11
S04422-11
–
3
Loosen screws
. Remove the left fork leg.
–
4
Loosen screws
. Remove the right fork leg.
Main work
–
Position the fork legs.
1
Bleeder screws
are positioned toward the front.
Info
The compression damping is located in left fork
leg COMP (white adjuster). The rebound damping is
located in right fork leg REB (red adjuster).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
–
2
Tighten screws
.
Guideline
Screw, top triple
clamp
–
3
Tighten screws
.
Guideline
Screw, bottom triple
clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
M8
17 Nm (12.5 lbf ft)
M8
15 Nm (11.1 lbf ft)
25 Nm (18.4 lbf ft)
Loctite
5
.
(
p. 99)
p. 112)
p. 115)
4
.
®
243™