Husqvarna TE 150i 2022 Owner's Manual page 78

12 SERVICE WORK ON THE CHASSIS
76
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides in
front of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or
damaged.
H03706-11
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
(TE 150i EU)
–
Position the horn with the horn bracket.
H03704-11
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H03705-11
–
Plug in connector
–
Remove the wash cap set.
–
Clean the quick release coupling thoroughly with compressed
air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
H03702-11
–
Spray silicone spray onto a lint-free cleaning cloth and lightly
lubricate the O-ring of the quick-release coupling.
Silicone spray (
–
Join quick release coupling
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
–
Attach the fuel tank breather hose.
Finishing work
–
Install the right side cover. (
–
Mount the seat. (
p. 82)
1
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
2
.
M6 10 Nm (7.4 lbf ft)
3
for the fuel pump.
p. 157)
4
.
p. 73)
p. 68)