Husqvarna TE 150i 2022 Owner's Manual page 110

15 ELECTRICAL SYSTEM
108
Info
Even when there is no load on the 12-V battery, it discharges steadily each day.
The charging level and the method of charging are very important for the service life of the 12-V battery.
Rapid recharging with a high charging current shortens the service life of the battery.
If the charging current or charging voltage are exceeded, the 12-V battery will be destroyed.
If the 12-V battery is depleted by repeated starting, the 12-V battery must be charged immediately.
If the 12-V battery is left in a discharged state for an extended period, it will become deeply discharged
and suffer a loss of capacity, destroying the battery.
The 12-V battery is maintenance-free.
F01568-10
Preparatory work
–
Remove the air filter box cover. (
–
Remove the seat. ( p. 68)
–
Remove the 12-V battery.
Main work
–
Check the battery voltage.
» Battery voltage: < 9 V
–
Do not charge the 12-V battery.
–
Replace the 12-V battery and dispose of the old 12-V
battery properly.
» If the specifications have been met:
Battery voltage: ≥ 9 V
–
Charge the 12-V battery.
Guideline
Maximum charging volt-
age
Maximum charging cur-
rent
Maximum charging time
Recharge the 12-V bat-
tery regularly when the
motorcycle is not being
used
Battery charger (26529974000)
This battery charger tests whether the 12-V battery
retains its voltage. It is also impossible to overcharge
the 12-V battery with this battery charger. The charg-
ing time may be longer at low temperatures.
This battery charger is only suitable for lithium iron
phosphate batteries. Observe the accompanying
instructions for Husqvarna Motorcycles technical
accessories.
Info
Never remove cover
–
Switch off the battery charger after charging and disconnect
from the 12-V battery.
Finishing work
–
Install the 12-V battery.
–
Mount the seat. ( p. 68)
p. 69)
( p. 104)
14.4 V
3.0 A
24 h
6 months
1
.
( p. 106)