Installing The Front Wheel; Removing The Rear Wheel - Husqvarna TE 150i 2022 Owner's Manual

14.2

Installing the front wheel

Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
14.3

Removing the rear wheel

–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Insert the spacers.
–
Clean and grease the wheel spindle.
H00935-10
Long-life grease (
–
Jack up the front wheel into the fork, position it, and insert
the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake
H03730-11
linings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with a lift stand. (
WHEELS, TIRES 14
1
and contact
of the spacers.
p. 157)
p. 157)
2
.
M20x1.5
3
.
M8
35 Nm (25.8 lbf ft)
p. 56)
15 Nm (11.1 lbf ft)
p. 56)
99