Cleaning The Oil Screen In The Oil Tank - Husqvarna TE 150i 2022 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.4
132
S04854-10
F02321-10

Cleaning the oil screen in the oil tank

Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
–
Plug in wake-up connector
6
diagnostics connector
The combination instrument lighting is activated.
Info
The connector is included as part of the motorcycle's
separate enclosure.
–
Wait for at least five seconds.
–
Release the fixing means from the throttle grip.
The oil pump is timed.
Info
The oil pump is actuated at various speeds.
The procedure is clearly audible.
–
Wait until you can no longer hear the oil pump operating.
–
Disconnect the wake-up connector from the diagnostics con-
nector.
–
Check whether air bubbles are visible in the hose
» If air bubbles are visible:
–
Repeat the entire procedure until air bubbles are no
longer visible.
–
Mount protection cap on the diagnostics connector.
–
Mount the EFI control unit on the rubber lugs.
Finishing work
–
Mount the seat. ( p. 68)
–
Install the air filter box cover. (
Preparatory work
–
Remove main silencer. (
–
Remove the air filter box cover. (
–
Remove the seat. ( p. 68)
–
Remove the right side cover. (
–
Remove the fuel tank.
–
Raise the motorcycle with a lift stand. (
5
for priming the oil pump to the
.
7
p. 69)
p. 71)
p. 69)
p. 73)
( p. 74)
p. 56)
.