Power Connector Cable - HP ProBook x360 11 G7 Education Edition Maintenance And Service Manual

1. Prepare the computer for disassembly (see
2. Remove the top cover with keyboard (see
3. Remove the battery (see
Remove the USB/audio board:
1. Release the ZIF connectors (1) to which the USB/audio board cables are connected, and then disconnect
the USB/audio board cables from the system board.
2. Remove the two Phillips M2.5 × 4.0 screws (2) that secure the USB/audio board to the computer.
3. Lift the right side of the USB/audio board (3) and swing it up and to the left to remove it.
Reverse this procedure to install the USB/audio board.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-11 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the top cover with keyboard (see
3. Remove the battery (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Remove the Torx T8 2.5 × 5.0 screw (2) that secures the power connector cable to the computer.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Top cover with keyboard on page
Battery on page 34).
Preparation for disassembly on page
Top cover with keyboard on page
Battery on page 34).
27).
27).
Spare part number
M03750-001
27).
27).