Solid-State Drive - HP ProBook x360 11 G7 Education Edition Maintenance And Service Manual

IMPORTANT:
information. To prevent loss of information, save your work or shut down the computer through Windows
before you remove the battery.
Remove the battery:
1. Remove the four Phillips M2.5 × 4.0 screws (1) that secure the battery to the computer.
2. Lift the rear edge of the battery (2) and swing it up and forward until it disconnects from the system
board.
3. Remove the battery (3) by sliding it back at an angle.
Reverse this procedure to install the battery.

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-6 Solid-state drive descriptions and part numbers
Description
256 GB, PCIe
128 GB, PCIe
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the top cover with keyboard (see
3. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 4.0 screw (1) that secures the drive to the computer.
Removing a battery that is the sole power source for the computer can cause loss of
Battery on page
(Preparation for disassembly on page
Top cover with keyboard on page
34).
Spare part number
L85354-005
M06792-005
27).
27).
Component replacement procedures 35