Removing Module
1. Remove power module shrouds. See 6.7.1 Power
Module Shrouds, page 24.
2. Unplug all cables from module.
3. Loosen and remove screw F, washer E and lock
washer D
4. Remove module B.
Installing Module
1. Install module B to top latch A from downwards
direction.
2. Swivel module to bottom latch C. Make sure that
module is correctly installed on inner sides of latches
(see figure on right side).
3.
Ensure to install lock washer D alongside to
module. Lock washer must have contact to
module for proper working.
Re-install screw, washer and lock washer. Tighten screw.
4. Re-install shrouds.
5. Plug in cables.
6. Perform calibration process. See in LiNX service manual.
7. Test all functions.
1654647-B
Fig. 6-44
Fig. 6-45
Fig. 6-46
Service
55