Invacare AVIVA RX Series Service Manual page 14

Invacare® AVIVA™ RX series
Available settings
Mounting
Position Seat Height
435 mm
A
460 mm
B
485 mm
C
CAUTION!
Risk of Crushing
Seat comes down when front or rear fixing of the seat are removed.
– Do not remove front and rear fixing of the seat at the same time.
– Hold the seat in position while removing the actuator.
– Place a wooden block between seat and chassis, or lower seat carefully to the chassis.
1. Remove SL retainer clip D and pin E on top fixation of
actuator. Hold seat in position.
2. Adjust seat height on top fixation according to table
Available settings, page 14.
3. Re-install SL retainer clip and pin.
4. Loosen screws F on both sides sightly.
5. Loosen and remove screws G and washers H on both
sides.
6. Adjust seat height at height adjustment bracket I
according to table Available settings, page 14.
7. Re-install washers and screws.
8. Tighten screws.
14
Fig. 4-5
Fig. 4-6
Fig. 4-7
1654647-B