Remove Screws - KTM 390 Duke EU Setup Instructions

3 WORK
3.1 Removing the passenger seat
3.2 Mounting the passenger seat
3.3 Removing the seat
3.4 Mounting the seat
–
Insert the ignition key in seat lock
–
Raise the rear of the seat, push it towards the rear, and remove it upwards.
–
Remove the ignition key from the seat lock.
101881-10
–
Attach hooks
it at the rear while pushing forward.
–
Press down the passenger seat until it clicks into place.
Warning
Danger of accidents The passenger seat can come loose from the anchoring
if it is not mounted correctly.
–
101890-10
–
Finally, check that the passenger seat is correctly mounted.
Preparatory work
–
Remove the passenger seat. (
Main work
–

Remove screws

–
Raise the rear of the seat, pull it towards the rear, and remove it upwards.
101891-10
Main work
–
Attach seat recesses
–
Mount and tighten screws
Guideline
Screw, seat
101892-10

 on the passenger seat to brackets
After mounting the passenger seat, check that it is locked correctly by
pulling up.
p. 5)
 .
 
at screws

.
and turn it clockwise.
 on the subframe, and lower
and lower at the rear.
M6 11 Nm (8.1 lbf ft)
5