Mount And Tighten Screw; Remove Screws; Mounting The Seat - KTM 250 SX Series Setup Instructions

3.8 Installing the start number plate
3.9 Removing the seat
3.10

Mounting the seat

–
Connect the brake line at the start number plate.
–
Position the start number plate.
The holding lugs engage in the fender.
–

Mount and tighten screw

F00013-10
–

Remove screws

–
Raise the rear of the seat, pull the seat back, and lift it off.
F00017-10
–
Mount the front of the seat on the collar bushing of the fuel
tank, lower the seat at the rear, and push the seat forward.
–
Make sure that the seat is correctly locked in.
F00016-10
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
F00017-10
1
.
1
.
1 .
M6 10 Nm (7.4 lbf ft)
3 WORK
15