Remove Screws - KTM 690 SMC R EU 2015 Setup Instructions

2 SETUP
–
Recharge the battery. (
–
Install the battery. (
–
Plug in connector
S00801-10
–
Remove the rear fairing. (
–
4 markings
drill holes to the specified diameter in three stages.
Guideline
Hole diameter for grab handles
S00802-10
–

Remove screws

–
Fit the rear fairing. (
S00803-10
–
Mount the reflector.
Operation as a 2-seater
–
Mount rear footrest bracket. (
Operation as a 1-seater (only if requested by customer)
201901-10
–
Mount heel protector. (
–
Refuel. (
–
Print out the current PDI form found on the KTM Dealer.net and perform the pre-
delivery inspection.
–
Set kilometers or miles. (
p. 7)
p. 8)
 on the starter relay.
p. 10)

are found on the underside of the rear fairing. At these location,

.
p. 10)
p. 10)
Warning
Forfeiture of homologation and insurance cover The vehicle is
homologated as 2-seater. If the heel protector is fitted instead of the
footrest bracket, the vehicle no longer conforms to the homologation and
must not be operated in this form without alterations to the registration
papers.
–
Set up and operate the vehicle as a 2-seater or have changes made
to the registration papers.
p. 11)
p. 11)
p. 12)
14.5 mm (0.571 in)
5