Table of Contents
Advertisement
3 WORK
3.1
3.2
6
Removing the start number plate
M01681-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
M01659-11
–
1
Remove screw
.
–
Unhook the start number plate from the brake line and remove
it.
–
1
Remove screws
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
2
Remove screws
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and
2
tighten screws
.
Guideline
Screw, handle-
M10
bar support
Mount the left and right handlebar supports in the same
position.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the installed gaps are even.
40 Nm (29.5 lbf ft)
Loctite
1
and tighten
M8
20 Nm (14.8 lbf ft)
®
243™
Advertisement
Table of Contents
