The TC Setup menu is available only when the 8347 is installed. The TC Setup menu screen has 3
pages and provides various setting items for time code recording/playback, jam function, etc.
To access to a TC Setup menu item, follow the procedure below.
1) While the FR-2 is stopped, press the [ENTER] key to enter the MENU mode.
The display now shows the first page of the MENU screen.
2) Use the [MENU] dial to select "TC Setup" at the bottom of this page and press the [ENTER] key.
The display now shows the first page of the TC Setup menu screen.
By rotating the [MENU] dial, you can bring up page 2 or 3.
Each page includes the following menu items.
Page 1
Page 2
Page 3
Details of the TC Setup menu
•
Selecting on/off of TC display (see page 9)
•
Selecting the frame rate of recording/playback time code and internal
generator time code (see page 9)
•
Editing the LTC start time at the ABS 0 point (see page 10)
•
Selecting the time code generator mode (see page 11)
•
Selecting the output time code source (see page 11)
•
Viewing or editing the time code value of the internal TC generator
(see page 12)
•
Setting the generator TC Ubit mode and user data (see page 15)
•
Setting the TC userbit while the output time code source is set to
"REPRO" (see page 16)
•
Selecting whether outputting time code or not while the unit is paused
(see page 16)
•
Selecting the jam mode when jamming to external time code while the
generator mode is set to "Free Run" (see page 17)
•
Executing force jam (see page 7)
•
Selecting the pull up/down function (see page 17)
•
Setting the next event number (see page 18)
•
Setting the power off time of the TC card after the FR-2 is turned off
(see page 18)
8