Viewing And Editing The Ltc Start Time [Edit Ltc Start] - Fostex FR-2 Owner's Manual

Viewing and editing the LTC start time [Edit LTC Start]

The "Edit LTC Start" menu item allows viewing and editing the LTC start time which is recorded at the
beginning of an audio file (ABS 0). The FR-2 records the LTC start time at the beginning of an audio
file and then the internal generator generates time code which follows the start time.
After bringing up the first page of the TC Setup menu, use the [MENU] dial to select "Edit LTC
Start" and press the [ENTER] key. The current LTC start time is shown.
• Editing the LTC start time
<Note>: You cannot undo LTC start time editing. So do not edit the LTC start time carelessly.
It is recommended that, before make editing, you should write down the LTC start time.
While the screen above right is shown, use the [MENU] dial to select "Edit >" and press the
[ENTER] key.
You can now edit the current LTC start time (the "h" field starts flashing).
Use the [MENU] dial to edit the value in the flashing field. You can move the flashing field to the
right by pressing the [ENTER] key or the [>>|] key. You can enter a desired value to each field
from left to right ("h" -> "m" -> "s" -> "f" -> "sf").
When you move the flashing field after editing the value of the current field, all lower fields of
the edited field are reset to "00".
After editing all fields, pressing the [ENTER] key fixes the edited LTC start time and the display
returns to show the screen where "Edit >" flashes.
To edit the MENU mode, select "<<Back" and press the [ENTER] key, or press the [HOME/HOLD
RESET] key.
10