Table of Contents
Advertisement
SECTION 2 – USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
General
Begin the "Walk-Around Inspection" at Item 1, as noted on
the diagram. Continue checking each item in sequence for
the conditions listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN
CORRECTED.
INSPECTION NOTE: On all components, make sure there
are no loose or missing parts, that they are securely fastened,
and no visible damage, leaks or excessive wear exists in
addition to any other criteria mentioned.
1. Platform Assembly and Gate - Gate opens and closes
properly, manual in storage container. See inspection
note.
2. Platform & Ground Control Consoles - Placards
secure and legible, control levers and switches return to
neutral and emergency stop switches function properly.
3. Steering Assembly - See inspection note.
2-6
4. Wheel/Tire Assemblies - Properly secured, no missing
lug nuts. Inspect for worn tread, cuts, tears or other dis-
crepancies. Inspect wheels for damage and corrosion.
See inspection note.
5. Hood Assemblies - See Inspection Note.
6. Hydraulic Cylinders- No visible damage, pivot pins and
hydraulic hoses undamaged, no leakage (hose connec-
tions - valve block).
7. Manual Descent - See Inspection Note.
8. Lifting Chains, Chain Yokes and Clevis Pins - Must be
installed and in good condition. Chains must be cor-
rectly tensioned and lubricated.
9. Hydraulic Pump/Oil Level in Reservoir - Swing needle
valve fully closed. See Inspection Note.
10. Limit Switches - Mast limit switch(es), chain slack limit
switches and overload sensor (if equipped) are properly
installed and fastened. See inspection note.
– JLG Lift –
31210162
Advertisement
Table of Contents
