Table of Contents
Advertisement
SECTION 6 – GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.14 DTC CHECK TABLES
0-0 Help Comments
DTC
FAULT MESSAGE
EVERYTHING OK
001
GROUND MODE OK
002
FUNCTIONS LOCKED OUT -
008
SYSTEM POWERED DOWN
RUNNING AT CUTBACK - OUT
0010
OF TRANSPORT POSITION
DIFFERENT FUNCTION
0022
SELECTED & IGNORED
FUNCTION SELECTED BUT
0023
TRIGGER SWITCH OPEN
6-30
DESCRIPTION
The normal help message in Platform Mode. Dis-
plays on the analyzer only.
The normal help message in Ground Mode. Dis-
plays on the analyzer only.
After 2 hours without activity, the Control System
enters a low-power state to preserve battery
charge. Displays on the analyzer only; the MDI's
LED is blinking with the display Off.
Drive speed is limited while the mast is elevated.
Displays on the analyzer only.
Two hydraulically powered movements simulta-
neously controlled.
One of the drive joystick functions was activated,
but the trigger switch was not.
– JLG Lift –
CHECK
• Normal operation should resume after a power cycle.
Refer problem to a qualified JLG mechanic.
• Fully stow the platform.
• Check that the mast switches are securely mounted.
Refer problem to a qualified JLG mechanic.
• Release joysticks and allow to center.
Refer problem to a qualified JLG mechanic.
• Release joystick and allow to center.
• Check if the joystick is obstructed or jammed.
• Check if the trigger switch is damaged.
Refer problem to a qualified JLG mechanic.
31210162
Advertisement
Table of Contents
