Turning The Power On/Off; Turning The Power On - Sony ZRD-1 Operating Instructions Manual

Turning the Power On/Off

Turning the Power On

You can turn on the system's power using one of three
methods. Consult your system administrator regarding
which method to use.
• Turning the power on via the display controller
• Turning the power on via Display Control Software
• Turning the power on by connecting the power cord to
the display controller
Caution
Always connect the display controller's power cord to the
circuit breaker.
Note
If a startup delay is configured in the [Function] - [System
Settings] - [Display Unit Power On Delay] setting of
Display Control Software, the display units will turn on
according to the configured delay.
Turning the power on via the display
controller
1
Press and hold the power switch on the display
controller for about 2 seconds.
Turn on all the display controllers by pressing each of
their power switches.
When a display controller turns on, its POWER
indicator lights green.
When a display unit turns on, its status indicator lights
green.
To enter standby mode
Press the power switch on a display controller twice to
set the display controller and display units to standby
mode.
To return to the power ON state, press and hold the
power switch again.
Note
If you press the power switch only once in the power
ON state, the POWER indicator will blink red for
2 seconds, but the standby mode will not be entered.
You can enter standby mode by pressing the power
switch again while the indicator is still blinking red.
2
Turn on the video source equipment.
Turning the power on via Display Control
Software
The initial settings must be configured beforehand to turn
the power on via Display Control Software. For details,
consult your system administrator.
1
Start the controller PC, and click [All Programs] -
[Display Control Software] - [Display Control
Software] in the start menu to start Display Control
Software.
2
Click [Power ON] in the main screen.
Under default settings, all display controllers and
display units will turn on.
When a display controller turns on, its POWER
indicator lights green.
When a display unit turns on, its status indicator lights
green.
When you click [Standby]
The power status of all connected display controllers
and display units will enter standby mode, and the
main screen will remain displayed.
Click [Power ON] to turn the power on again.
3
Turn on the video source equipment.
Turning the power on by connecting the
power cord to the display controller
When [Function] - [System Settings] - [Direct Array
Power On] is set to [ON] in Display Control Software
beforehand, simply connecting the display controller's
power cord will turn on the display controller and display
units.
1
Connect the power cord to the - IN connector on the
display controller.
When a display controller turns on, its POWER
indicator will switch from blinking red/orange to
remaining lit green.
When a display unit turns on, its status indicator lights
green.
2
Turn on the video source equipment.
8