Cleaning And Storage; Display Units; Display Controllers; Signal Formats - Sony ZRD-1 Operating Instructions Manual

Cleaning and Storage

Display Units

Caution
Do not wet the surface of the display units.
Daily cleaning
• Use a soft anti-static cloth that does not produce lint
when cleaning the surface of the display units.
• Use ethyl alcohol (near 100%) to clean stubborn stains
on the surface. Do not use any other solvents.
• Use commercially available anti-static dust blowers to
clean joints.
Storage (for transportation)
• Make sure the display units are completely dry before
packing them.
• Store the display units in dry, well-ventilated
environments.

Display Controllers

Daily cleaning
• Use a cloth that has been dampened with a neutral
detergent and thoroughly wrung out to wipe the device
clean. Never use solvents, such as benzene and thinners.
Storage
• Do not store in environments where condensation may
occur inside the device.

Signal Formats

The system supports the following video signals.
DisplayPort (single input)
Resolution Input frame rate
2)
3840 × 2160 60p/50p/30p/25p/
24p
2)
1920 × 2160 120p
60p/50p/30p/25p/
24p
1920 × 1080 120p/100p/60p/
50p/30p
DisplayPort (dual input)
Resolution
Input frame rate
3)
3840 × 2160 120p/100p
DVI (1 input)
Resolution
Input frame rate
1920 × 1080 60p/50p/30p/25p/
24p
DVI (4 input)
Resolution
Input frame rate
4)
3840 × 2160 60p/50p/30p/25p/
24p
1) 1,000/1,001 frame rate is also supported.
2) Only multi-stream is supported.
3) Supported by two input signals of 1920 × 2160, 100p/120p.
4) Supported by four input signals of 1920 × 1080.
17
1)
Input bit Input color
length sampling
8-/10-bit RGB 4:4:4
2)
/100p / 8-/10-bit RGB 4:4:4
8-/10-bit RGB 4:4:4
1)
Input bit Input color
length sampling
8-/10-bit RGB 4:4:4
1)
Input bit Input color
length sampling
8-bit RGB 4:4:4
1)
Input bit Input color
length sampling
8-bit RGB 4:4:4