Table of Contents
Advertisement
300 STARTING AND OPERATING
To activate the system, push the bottom of the AXLE LOCK
switch once to lock the rear axle only (the "Rear Axle Lock
Indicator Light" will illuminate), push the bottom of the
switch again to lock the front axle (the "Front Axle Lock
Indicator Light" will illuminate). When the rear axle is
locked, pushing the bottom of switch again will lock or
unlock the front axle.
NOTE: The indicator lights will flash until the axles are
fully locked or unlocked.
To unlock the axles, push the top of the AXLE LOCK
switch.
Axle lock will disengage if the vehicle is taken out of 4L
(Low) range, or the ignition switch is turned to the OFF
position.
Electronic Sway Bar Disconnect — If Equipped
Your vehicle may be equipped with an electronic discon-
necting stabilizer/sway bar. This system allows greater
front suspension travel in off-road situations.
This system is controlled by the SWAY BAR switch located
on the instrument panel (to the left of the steering column).
Sway Bar Switch
Push the SWAY BAR switch to activate the system. Push
the switch again to deactivate the system. The "Sway Bar
Indicator Light" (located in the instrument cluster) will
illuminate when the bar is disconnected. The "Sway Bar
Indicator Light" will flash during activation transition, or
when activation conditions are not met. The stabilizer/
sway bar should remain in on-road mode during normal
driving conditions.
Advertisement
Table of Contents
