Table of Contents
Advertisement
3. Remove the soft top bow assembly pivot bracket screws
(two per side) using a #T30 Torx head driver.
Step Three
4. Disconnect the knuckles from the left and right metal
pivot brackets. Remove the soft top from the vehicle and
store in a clean, dry location.
NOTE: To aid in disconnecting the knuckles, you may
carefully tap on the knuckles using a rubber mallet.
GETTING TO KNOW YOUR VEHICLE 73
Step Four
5. Unzip the zipper on the sport bar cover to expose the
pivot brackets. Remove the brackets using a #T30 Torx
head driver. Recover and re-zip the sports bar cover.
Store the pivot brackets and screws in a safe place.
6. Reinstall the hard top. Refer to "Freedom Top Three-
Piece Modular Hard Top — Front/Rear Panel Installa-
tion" in this section.
3
Advertisement
Table of Contents
