Table of Contents
Advertisement
76 GETTING TO KNOW YOUR VEHICLE
6. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective
cover for shipping only.
NOTE: A visual instruction sheet is enclosed in the dual
top wrap.
7. Put up the soft top. Refer to "Soft Top — Raising The
Soft Top" in this section.
DUAL TOP — FOUR DOOR MODELS — IF
EQUIPPED
Please visit http://www.jeep.com/en/wrangler-rooftop-
instructions/ for instructional videos.
If your vehicle is equipped with a Dual Top, you must
remove one of the tops from the vehicle. If the soft top is
removed, the pivot brackets must also be removed from
the sport bar. The soft top was installed at the factory for
shipping purposes only. The soft top and the hard top are
to be used independently. Removal is mandatory to
prevent any possible wear and tear on the soft top. Your
vehicle warranty will not cover damage resulting from
both tops remaining on the vehicle at the same time for
extended periods of time.
Removing The Soft Top — Four Door Models
1. Locate and remove the two boxes that contain the
following items:
• Right and left door frames
• Six door frame attachment knobs
• Right and left quarter windows
• Rear window
• Two rear window roll up straps
• Two Sunrider secure straps (if equipped)
• Two rear swing gate brackets
2. Remove the hard top. Refer to "Freedom Top Three-
Piece Modular Hard Top — Front/Rear Panel Removal"
in this section.
Advertisement
Table of Contents
