Work On The Clutch Cover; Removing Crankshaft Bearing Inner Ring; Removing Balancer Shaft Drive Wheel; Changing The Connecting Rod, Conrod Bearing, And Crank Pin - KTM 690 Enduro R EU 2012 Repair Manual

17 ENGINE
17.4.3

Work on the clutch cover

17.4.4

Removing crankshaft bearing inner ring

17.4.5

Removing balancer shaft drive wheel

17.4.6

Changing the connecting rod, conrod bearing, and crank pin

–
Remove the shaft seal ring
–
Press in a new shaft seal ring with the open side facing inward until it stops.
Info
Support the clutch cover sufficiently when pressing in.
–
Blow compressed air through the oil channel and check that it is clear.
300097-10
–
Fix the crankshaft with special tools
Upper part, pressing-out tool (75029047050) (
Under part, pressing-out tool (75029047051) (
302145-10
–
Heat the special tool
Guideline
150 °C (302 °F)
Tool for inner bearing race (58429037043) (
–
Push the heated special tool
together, and pull them together off the crankshaft.
–
Take off the compensation shim.
–
Repeat the operation on the opposite side.
302146-10
Preparatory work
–
Remove the crankshaft bearing inner ring. (
Main work
–
Screw in 2 M6 screws
drive wheel
302147-10
Preparatory work
–
Remove the crankshaft bearing inner ring. (
–
Remove the drive wheel of the balancer shaft. (
of the crankshaft.
1
1
.
3
on to the inner bearing race, press them hard
3
in the threads. Tighten the two screws evenly to pull the
1
off the crankshaft.
2
and in the vise.
2
p. 220)
p. 220)
p. 215)
p. 125)
p. 125)
p. 125)
125