Table of Contents
Advertisement
•
For hotter coffee, see the section " Tips for a hotter coffee".
Important!
If the coffee is delivered a drop at a time, too fast and not cre-
amy enough or too cold, read the tips in the "Troubleshooting"
section on page 22.
Various alarm messages could be displayed while the machine
is in use. Their meaning is explained in the section "Displayed
messages" (page 21).
making coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
•
Never use more than one level measure or it could dirty
the inside of the machine or block the funnel.
Please Note!
If you use pre-ground coffee, you can
only make one cup of coffee at a time.
1. Repeatedly press the selection icon
(C4) corresponding to the "taste"
bar until "Ground" and
splay.
2. Put one level measure of pre-ground coffee into the fun-
nel (fig. 15).
3. Place a cup under the coffee spouts (fig. 8).
4. Press the 1 cup coffee icon
5. Preparation begins. A cup appears on the display and gra-
dually fills as preparation progresses.
Once the coffee has been made, the appliance prepares for use
again.
maKinG DrinKs With milK
Please Note!
If "Energy Saving" mode is enabled, you may have to wait a few
seconds before the drink is delivered.
filling and attaching the milk container
1. Turn the lid of the milk container clockwise until it beco-
mes noticeably difficult to turn, then remove the lid (fig.
16).
2. Fill the milk container with a sufficient quantity of milk,
not exceeding the MAX level marked on the handle (fig.
17).
-
flash on the di-
+
-
+
-
+
-
+
-
+
(fig. 9).
-
+
Please Note!
For a richer denser froth, use skim or 2% milk at refrigerator
temperature (about 41°F / 5°C).
To avoid milk with poor froth or large bubbles, always clean
the milk lid and hot water nozzle as described in the section
"Cleaning the milk container" on page 16 and 18.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (fig. 18).
4. Replace the milk container lid and turn anticlockwise as
far as it will go.
5. Remove the hot water spout from the nozzle (fig. 19).
6. Attach the container to the nozzle and push as far as it
will go (fig. 20). The machine emits a beep (if the beep
function is enabled).
7. Place a sufficiently large cup under the coffee spouts and
frothed milk spout (fig. 21). To use particularly tall cups/
glasses, raise the lid of the special compartment in the
cup tray (fig. 22).
8. Follow the instructions below for each function.
making caffelatte
1. After attaching the milk container (see previous section),
position the froth regulator on caffElattE (fig. 23) prin-
ted on the milk container lid.
2. Press the caffElattE icon (fig. 24).
A cup is displayed and gradually fills as preparation pro-
gresses. After a few seconds, frothed milk is delivered
from the milk spout into the cup below. Milk delivery
stops automatically and coffee delivery begins.
3. At the end of delivery, the machine is automatically ready
for use again.
Please Note!
If during delivery you want to stop preparing milk, press the
caffElattE icon or interrupt preparation of the coffee by
pressing the
icon.
making cappuccino
1. After attaching the milk container (see previous section),
position the froth regulator on CAPPUCCINO printed on
the milk container lid (fig. 25).
The quality of froth can be adjusted during delivery by
moving the regulator slightly towards lattE macchia-
to for a denser froth.
2. Press the cappuccino icon (fig. 26). A cup is displayed
and gradually fills as preparation progresses. After a few
seconds, frothed milk flows out of the milk spout into the
cup below. Milk delivery stops automatically and coffee
delivery begins.
15
Advertisement
Table of Contents
Troubleshooting
