Table of Contents
Advertisement
(When in the settings MENU, they change function ac-
cording to the text shown above the icon).
cappuccino icon: to deliver a cappuccino.
C8.
C9.
caffElattE icon: to deliver a caffelatte.
C10.
Selection icon to choose the coffee quantity.
(When in the settings MENU, it changes function accor-
ding to the text shown above the icon).
C11.
icon: to activate the hot water function.
C12.
p icon: to access or exit the settings menu.
Please Note :
A light touch is enough to activate the icon.
meaning of animations
Below is an explanation of the animations describing the ope-
ration the appliance is currently performing:
RINSING.
HEATING UP.
IMPORTANT MESSAGE
(see section: "Displayed messages").
PLEASE WAIT...
FILL TANK!
HOT WATER
prEliminary chEcKs
checking the appliance
After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories are present. Do
not use the appliance if it is visibly damaged. Contact De'Longhi
Customer Services. Please see enclosed guarantee leaflet.
installing the appliance
Important!
When you install the appliance, you should respect the fol-
lowing safety warnings:
•
The appliance gives off heat. After positioning the ap-
pliance on the worktop, leave a space of at least 3 cm
between the surfaces of the appliance and the side and
rear walls and at least 15 cm above the coffee maker.
•
Water penetrating the appliance could cause damage. Do
not place the appliance near water faucets or sinks.
•
The appliance could be damaged if the water it contains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
•
Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.
using the appliance for the first time
Please Note :
•
Coffee has been used to factory test the appliance and it
is, therefore, completely normal for there to be traces of
coffee in the mill. The machine is, however, guaranteed to
be new.
•
You should customize water hardness as soon as possible
following the instructions in the section "Setting water
hardness" on page 19.
1. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(fig. 1).
You must first choose the language on the display (the langua-
ges scroll through at intervals of about 3 seconds).
2. When English appears, press the selection icon corre-
sponding to OK on the display for a few seconds (fig. 2).
Once the language has been saved, the message "English
installed" is displayed.
Follow the instructions indicated by the appliance:
3. "FILL TANK!": remove the water tank, fill to the MAX line
with fresh water then replace in the appliance (fig. 3).
4. "INSERT WATER SPOUT! ": Check that the hot water spout is
inserted on the nozzle and place a container with a mini-
mum capacity of 100 ml underneath (fig. 4).
10
Advertisement
Table of Contents
Troubleshooting
