Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Related Manuals for DeLonghi ESAM5450
Summary of Contents for DeLonghi ESAM5450
- Page 1 5713213231/ 12.09...
- Page 2 BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instructions for use ESAM5450...
-
Page 3: Electrical Requirements
ElECTRICAl REqUIREMENTS Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. - Page 4 Ready espresso...
-
Page 7: Table Of Contents
CONTENTS FROTHING THE MIlk (FOR CAPPUCCINO) AND REHEAT MIlk (FOR lATTE) ....14 ElECTRICAl REqUIREMENTS ....2 Frothing milk for cappuccino ......14 Making hot milk (without froth) .......15 INTRODUCTION ........7 Cleaning the cappuccino maker after use..15 Symbols used in these instructions ....7 letters in brackets ..........7 HEATING WATER ........15 Troubleshooting and repairs ......7... -
Page 8: Introduction
INTRODUCTION SAFETY Thank you for choosing the eSaM5450 bean to Fundamental safety warnings cup espresso and cappuccino maker. Danger! We hope you enjoy using your new appliance. This is an electrical appliance and may therefore Take a few minutes to read these instructions. -
Page 9: Designated Use
DESIGNATED USE DESCRIPTION This appliance is designed and made to prepare Description of the appliance coffee and heat drinks. (page 3 - all other use is considered improper. grinding adjustment knob This appliance is not suitable for commercial Beans container lid use. -
Page 10: Explanation Of Lights
P button: to access the Programming Connecting the appliance menu. Important! B10. button: turns the appliance on and Check that the mains power supply voltage off. corresponds to the value indicated on the rating plate on the bottom of the appliance. Explanation of lights indicates the need to descale the Connect the appliance to an efficiently earthed... -
Page 11: Turning The Appliance On
The appliance ends the first start up procedure, avoid contact with splashes of water. then the message “Turning off, Please Wait...” is To turn the appliance off, press the button displayed and the appliance goes off. (fig. 4). The appliance performs the rinse cycle The coffee maker is now ready for normal use. -
Page 12: Energy Saving
displayed; 3. Press the button; Press the button: the hours flash on 4. Turn the selection knob until the required the display; language is displayed; 4. Turn the selection knob to change the 5. Press the button to confirm; hours; 6. -
Page 13: Auto-Off (Stand By)
Default values (reset) 5. Press the button to exit the menu: the This resets all menu settings and programmed symbol is no longer displayed. quantities back to the default values (with the Auto-off (Stand by) exception of the language which remains as set The appliance is set to turn off automatically if previously). -
Page 14: Customising The "My Coffee" Quantity
Customising the “MY COFFEE” quantity from the spout, heating the internal circuits The appliance is set by default to automatically and making the coffee delivered hotter; deliver 30 ml of “my coffee”. • enable the cup warmer and leave the cups to To modify these settings, proceed as follows: warm;... -
Page 15: Making Coffee Using Pre-Ground Coffee
and not creamy enough or too cold, read the tips place a container underneath (fig. 4). in the “Troubleshooting” section on page 21. 2. Press the button until the light various messages (fill tank, empty grounds comes on. container, etc.) could be displayed while using the machine. -
Page 16: Making Hot Milk (Without Froth)
HEATING WATER Important! Danger of burns Stop steam delivery before removing the Preparation container with the frothed milk to avoid burns Important! Danger of burns. caused by splashes of boiling milk. never leave the machine unsupervised while delivering hot water. Stop delivery of hot water 10. -
Page 17: Cleaning
ClEANING Cleaning the drip tray Important! Cleaning the coffee maker if the drip tray is not emptied regularly, the water The following parts of the machine must be could overflow from the edge and seep inside or cleaned regularly: around the machine. coffee grounds container (a9), This could damage the machine, the surface it... -
Page 18: Cleaning The Pre-Ground Coffee Funnel
blocked. if necessary, remove coffee deposits Please note! with a toothpick (fig. 26). if you encounter difficulty inserting infuser, Cleaning the pre-ground coffee funnel before inserting it you Check regularly (about once a month ) that the must adapt it to the right pre-ground coffee funnel is not blocked. -
Page 19: Setting Water Hardness
Place an empty container with a minimum Measuring water hardness 1. remove the “ToTal hardneSS TeST” indi- capacity of 1.5 litres under the hot water cator paper attached to this manual from its spout. pack. Important! danger of burns 2. immerse the paper completely in a glass of hot water containing descaling solution flows water for one second. -
Page 20: Technical Specification
TECHNICAl SPECIFICATION voltage: 220-240 v~ 50/60 hz max. 10a absorbed power: 1450W Pressure: 15 bar Water tank capacity: 1,7 l Size lxhxd: 284x380x440 mm Cable length: 1,5 m Weight: 11,4 Kg Beans container capacity: 250 g The appliance complies with the following eC directives: • Stand-by Directive no. 1275/2008;... -
Page 21: Displayed Messages
DISPlAYED MESSAGES DISPlAYED MESSAGE POSSIBlE CAUSE REMEDY Fill TanK ! • Insufficient water in the tank. • Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place. ground Too Fine • The grinding is too fine and the coffee is • Repeat coffee delivery and turn the delivered too slowly. grinding adjustment knob one click adJuST Mill! clockwise towards “7”... -
Page 22: Troubleshooting
TROUBlESHOOTING Below is a list of some of the possible problems. if the problem cannot be resolved as described, contact a Customer Service. PROBlEM POSSIBlE CAUSE SOlUTION The coffee is not hot • The cups were not preheated. • Enable the cup warmer, leave the cups at least 20 minutes to warm up. •... - Page 23 PROBlEM POSSIBlE CAUSE SOlUTION The milk is not frothed • Cappuccino maker dirty. • Clean as described in the section “Cleaning the cappuccino maker after use” on page 14. The appliance does not • It is not plugged into the mains socket. • Plug into the mains socket. come on. • The main switch (A8) is not turned on. • Place the main switch in the I position (fig. 1).