F48Ti Module; F48Ti Module - Extreme Networks Alpine 3804 Hardware Manual

The following example configures the automatic interface costs for 10 Mbps, 100 Mbps, 1 Gbps, and 10
Gbps interfaces:
config ospf metric-table 10m 20 100m 10 1g 8 10g 4
For more information about this and other ExtremeWare commands, see the ExtremeWare Software
Command Reference Guide.

F48Ti Module

Figure 122 shows the F48Ti module.
Figure 122: F48Ti module
Module status LEDs
10/100 Mbps ports
with status LEDs
The F48Ti has 48 autosensing 10BASE-T/100BASE-TX ports. All ports use standard RJ-45 connectors.
The default configuration of the F48Ti module is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in auto-negotiation mode.
LEDs
The F48Ti module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the F48Ti module, see "I/O Module LEDs" on
page 271.
Software Requirements
The F48Ti module requires that you load ExtremeWare version 6.1.4 or later on the switch.
Extreme Networks Consolidated Hardware Guide
52011
STATUS DIAG
XM_F48Ti
Configuring I/O Modules
245