10Glri Module - Extreme Networks Alpine 3804 Hardware Manual

10GLRi module

Figure 121 shows the 10GLRi module.
Figure 121: 10GLRi module
Module status LEDs
The 10GLRi module has one 10GBASE-LR port that supports single-mode fiber using standard SC
connectors. The module has the bandwidth to blow through any bottleneck and has bandwidth
management, traffic shaping, and policy-based QoS capabilities. The module is a single slot I/O module
for the BlackDiamond 6808 chassis. No chassis upgrade is required, and the MSM64i modules support
the 10GLRi module.
The default configuration of the module is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in auto-negotiation mode.
When you install the fiber-optic cable using the SC connectors, be sure you hear a "click" as the cable is
installed. This sound ensures that you have properly seated the connector and that it is completely
latched in the port. If the cable is not fully inserted in the port, the link my have many errors and my
not come up properly. You must use single-mode fiber-optic cable.
Table 67 summarizes the optical parameters for the 10GLRi module.
Table 67: 10GLRi optical parameters
Parameter
Minimum launch power
Maximum receiver
sensitivity 1
Minimum extinction ratio
Minimum distance
Extreme Networks Consolidated Hardware Guide
Port status LED
10 Gbps port
XM_042
Value
1,2 -6.2 dBm
-12.6 dB
3.5 dB
10 km
Configuring I/O Modules
243