Installing The Ac Power Cable Retaining Bracket; Removing The Retaining Screws From The Summit48Si Power Supply; Removing The Summit48Si Power Supply - Extreme Networks Alpine 3804 Hardware Manual

Summit Switch Installation
Figure 47: Removing the retaining screws from the Summit48si power supply
3 Use the handle to slowly pull the power supply towards you, as shown in Figure 48.
WARNING!
Do not insert your fingers or hands into the empty power supply bay.
Figure 48: Removing the Summit48si power supply
4 If you are not going to install a replacement power supply, cover the power supply bay with the
blank faceplate that was originally supplied with the switch. Otherwise, follow the Summit48si
power supply installation procedure to install a new power supply.
To install a Summit48si power supply:
1 Remove the blank faceplate from the power supply bay.
2 Use the handle to gently slide the power supply into the bay.
3 Replace and tighten the two captive retaining screws using a #2 Phillips screwdriver.
4 To turn the power supply on, connect the AC power cable to the power supply and then to the wall
outlet.
WARNING!
Do not plug in the power cable into the power supply unless the power supply is installed.
5 Keep the faceplate and the power supply packaging for future use.

Installing the AC Power Cable Retaining Bracket

This section describes how to install the AC power cable retaining bracket on a Summit switch.
To install an AC power cable retaining bracket:
112
48i1_01
48i1_02
Extreme Networks Consolidated Hardware Guide