Product Preservation - Kohler LOMBARDINI MARINE KDI 1903M-MP Owner's Manual

NOTE: if the inside of the pipes on surfaces
F1 and F2 (Fig. 5.7) are clogged with
deposits even after having been cleaned
as per step 6, the pipes must be cleaned
using specific mechanical tools.
Important
• Replace all the gaskets.
9. Fasten cap E2 onto manifold G using capscrews D2,
inserting flange E3 and also inserting:
- gasket H1 between E2 and E3
- gasket H2 between E3 and G.
- (tightening torque: MIN 5 Nm, MAX 7.5 Nm)
10. Insert gasket H3 in radiator F.
11. Insert radiator F all the way into manifold G.
12. Insert gasket H4 in radiator F.
13. Fasten cap E1 onto manifold G using capscrews D1
(tightening torque: MIN 5 Nm, MAX 7.5 Nm).
14. Clamp capscrew B on cap E1, inserting gasket H5
(tightening torque 30 Nm).
15. Screw union A onto manifold G.
16. Perform the operations described in Par. 4.6.
G H4 F
5.10

5.7 Product preservation

Important
• If the engines are not to be used for 6 months, they must
be protected by carrying out the operations described in
Engine storage (up to 6 months) (Par. 5.8).
• If the engine is still not in use after the first 6 months, it
is necessary to carry out a further operation to extend the
protection period (more than 6 months) (Par. 5.9).
• If the engine is not to be used for an extended period, the
protective treatment procedure must be repeated within 24
months of the previous one.
ED0053030870 _04
INFORMATION ABOUT MAINTENANCE
E1 D1
D2 E2
5.8
G H3
5.9
B
H5
G
5.11
5.8 Engine storage (up to 6 months)
Before storing the engine check that:
• The environments are not humid or exposed to bad weather.
Cover the engine with a proper protective sheet against
dampness and atmospheric contaminants.
• The place is not near electric panel.
• Avoid storing the engine in direct contact with the ground.
5
G
H1 E3 H2
F H4
E1
A
27 EN