together until handle shaft is fully seated into drive shaft.
5.
Tighten clamping bolts (A).
/
HANDLE SHAFT
1.
Remove protective cap from drive shaft end.
2. Loosen two (2) clamping screws (A) and remove locating screw
(B).
together until locating hole in shaft is visible through locating hole
in engine housing.
5.
Install locating screw and tighten clamping bolts.
POWER HEAD
P
P
OWER
O
'
PERATOR
S
TM
RUNER
11
M
ANUAL
A
B
A