Contents; Assembly; Drive Shaft / Power Head - Echo SHC-265 Operator's Manual

c
ontents
The ECHO product you have purchased has been factory pre-assembled for your convenience. Due to packaging restric-
tions, some assembly of the SHC-260 is required.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
___ 1 - Power Head
___ 1 - Gear Case Assembly
___ 1 - Drive Shaft Assembly
___ 1 - Operator's Manual
___ 1 - Hedge Clipper Safety Manual
___ 1 - Warranty Registration Card
___ 1 - Blade Cover
___ 1 - 4 mm Hex Wrench
a
ssembly
Tools Required: 4 mm Hex Wrench
Parts Required: Power Head, Drive Shaft Assembly, and Gear
Housing Assembly.
/
drIve shaft power head
1. Stand power head upright on a level surface.
2. Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft
clamp, and remove center drive shaft location bolt (A).
3. Carefully fit driveshaft assembly to engine making sure that
inner drive shaft engages clutch mount.
4. Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (A).
S h C
haft edge
O ' M
peratOr S
b
b
A
9
lipper
anual