Table of Contents
Advertisement
1.
POWER HEAD
2.
THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration press trigger gradu-
ally for best operating technique.
3.
SHOULDER HARNESS - An adjustable strap that suspends the unit from the operator.
4.
CUTTING ATTACHMENT -
5.
CUTTING SHOE
ate and lower saw chain into branch.
6. GUIDE BAR - 305 mm (12 in.) guide bar.
7. SAW CHAIN -
8. AUTOMATIC OILER ASSEMBLY -
9.
LOWER SHAFT TUBE
10. STOP SWITCH
11. THROTTLE TRIGGER LOCKOUT - This lever must be depressed before throttle trigger can be operated.
12. THROTTLE HANDLE ASSEMBLY - Sturdy handle for right hand placement. Includes stop switch and throttle
trigger.
13. TOP GUARD - Protects arm from hot engine.
14. RECOIL STARTER
return handle slowly. DO NOT let handle snap back or damage will occur.
15. SPARK ARRESTOR - CATALYTIC MUFFLER / MUFFLER -
16. FUEL TANK
17. FUEL TANK CAP - Covers and seals fuel tank opening.
18. CHOKE - Located above air cleaner housing. Move lever to starting position (
position (
) (open choke).
19. AIR CLEANER ASSEMBLY
20. PURGE BULB
bulb an additional 4 or 5 times.
21. SPARK PLUG - Provides spark to ignite fuel mixture.
22. GUIDE BAR COVER -
cover before using unit.
P
P
OWER
O
'
PERATOR
S
) (close choke) and back to run
TM
RUNER
9
M
ANUAL
-
Advertisement
Table of Contents
