Table of Contents
Advertisement
INSTALLATION
This section covers simple steps and detail installation. Please follow instruction for preventing
any unnecessary damage.
Simple Steps:
1. Connect to 26mm/1.06" EMT Conduit Pipe and lock it with Hex Wrench
2. Open camera bubble cover
3. Connect to testing monitor(optional accessories)
4. Adjust lens, camera position
5. Optional adjust camera setting on Dip Switch
1. Mount Camera
2.5mm Hex
Wrench
a. Pre-install 26mm/1.06" EMT conduit pipe and wire video and power cables though conduit
pipe. Connect power and video to the camera.
b. Locking pipe with camera by tightening set screws with supplied Hex wrench.
Note!! When connect to 12VDC with Power Extension cable . Please make sure you
connect powr
+,- correctly. Wrong connection may damage the camera.
26mm EMT
Conduit Pipe
Set Screws
5
Camera
Advertisement
Table of Contents
